Kenwood KOS-V500 Instruction Manual - Page 72
Help?
UPC - 019048171528
View all Kenwood KOS-V500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Help? Troubleshooting Some functions of this unit may be disabled by some settings made on this unit. ! • Cannot set up the subwoofer. • Cannot set up subwoofer phase. • No output from the subwoofer. • Cannot set up the low pass filter. • Cannot set up the high pass filter. ▲ Subwoofer is not set to On. ☞ (page 52) ▲ The Dual zone function is enabled. ☞ (page 70) ! Cannot set up the subwoofer phase. ▲ Subwoofer is not set to On. ☞ (page 52) ▲ Low pass filter is set to Through. ☞ (page 53) ! • Cannot select the output destination of the subsource in the Dual zone. • Cannot adjust the volume of the rear speakers. ▲ The Dual zone function is disabled. ☞ (page 70) ! Cannot Folder select. ▲ The Scan play or Random play function is enabled. ! • Cannot set up the equalizer. • Cannot set up the crossover network. ▲ The Dual zone function is enabled. ☞ (page 70) What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. General ? The Touch Sensor Tone doesn't sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can't be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on (page 76). Audio file source ? The sound skips when an Audio file is being played. ✔ The recording condition is bad. ☞ Record the media again or use another media. 72 KOS-V500