Kenwood MP928 Instruction Manual - Page 12

General features Subwoofer Output Turning the Subwoofer output ON or OFF. Hold down on [AM] of the Control knob for at least 1 second. Each time you press the button, Subwoofer output switches ON and OFF. When it is ON, "SUBWOOFER ON" is displayed. • You can control this function when "2ZONE" of (page 11) is set to "OFF". • You can control this item when Speaker Select Subwoofer of (page 13) is set to any item other than "None". 12 3 Sound Field control item "X'Over" "HPF Front" "fc" Front High Pass Filter Frequency "SLP" Front High Pass Filter Slope "HPF Rear"*¹ "fc" Rear High Pass Filter Frequency "SLP" Rear High Pass Filter Slope "LPF "fc" Subwoofer Low Pass Filter Frequency SubWoofer"*² "SLP" Subwoofer Low Pass Filter Slope "Phase" Subwoofer Low Pass Filter Phase "DTA" "DTA Front" DTA Front "DTA Rear"*¹ DTA Rear "DTA SubWoofer"*² DTA Subwoofer "POSI" Position Setting "Preset" Preset value storage/recalling Sound Field Control 1 Select the source to adjust Press the [SRC] button. 2 Show the Multi-function display Press the [NEXT] button repeatedly until "S.F.C" appears. Refer to (page 9). 3 Enter Sound Field Control mode Turn the [VOL] knob to select "S.F.C". Press the [VOL] knob. • To get the best sound, first set the Cabin Setting and Speaker Select Front/Rear parameters using the (page 13). • When "2ZONE" of (page 11) is ON, you cannot select "S.F.C". 4 Select the Sound Field Control item to adjust 1 Turn the [VOL] knob to select the item you want to select. Press the [VOL] knob. 2 Press the Control knob. 3 Push the Control knob towards [FM] or [AM]. • "Preset": You can store an adjusted sound control value by selecting "Memory". Refer to (page 16). Also, you can recall it by selecting "Recall". Refer to (page 16). • You can adjust "SubWoofer" when (page 12) is set to "SUBWOOFER ON". • X'Over (Crossover Network Setup) You can manually set a crossover frequency for the speakers. • DTA (Digital Time Alignment) Manually set the sound output timing of each channel. • *1 You can control this item when Speaker Select Rear of (page 13) is set to any item other than "None". • *2 You can control this item when Speaker Select Subwoofer of (page 13) is set to any item other than "None". 5 Adjust the Sound Field Control item Push the Control knob towards [4] or [¢]. Each time you push the knob, the setting alternates between the settings shown in the table below. Sound Field Control Item Front High Pass Filter Frequency/ Rear High Pass Filter Frequency Front High Pass Filter Slope/ Rear High Pass Filter Slope/ Subwoofer Low Pass Filter Slope Subwoofer Low Pass Filter Frequency Subwoofer Low Pass Filter Phase Range Through/40/60/80/100/120/ 150/180/220 (Hz) -12/-18 dB/Oct 40/60/80/100/120/150/180/ 220 (Hz)/Through Normal/ Reverse 12 | English