Kenwood MP928 Instruction Manual - Page 5

Notes • If you experience problems during installation, consult your Kenwood dealer. • If the unit fails to operate properly, press the Reset button to restore factory settings. • Press the reset button if the disc auto changer fails to operate correctly. Normal operation should be restored. Reset button • We recommend the use of (page 44) to prevent theft. • The characters conforming to ISO 8859-1 character set can be displayed. • There are places in this manual where lit indicators are described; however, the only time an indicator will light is in the following settings. When Indicator is selected as mentioned in (page 22) • The illustrations of the display and the panel appearing in this manual are examples used to explain more clearly how the controls are used. Therefore, what appears on the display in the illustrations may differ from what appears on the display on the actual equipment, and some of the illustrations on the display may be inapplicable. Before using this unit for the first time This unit is initially set on the Demonstration mode. When using this unit for the first time, cancel the (page 52). About ODD (Offset Dual Differential) D/A System You can enjoy high quality sound play when playing music CDs with the ODD D/A System enabled. ODD D/A System has two built-in D/A converters and each D/A converter processes D/A conversion seperately on the front left and right channel. Since digital processing is performed for each channel seperately, noise occurance from interference between channels is completely suppressed and the seperation of audio sound output from two channels is distinguished and clear. Also, the ODD/A System produces the data by which the sound data is offset on the minus side and converts the two signals (original and offset data) to the analog signal, which has less noise and distortion, by the synthetic process. However, ODD D/A System will be disabled if the following settings are selected. - When "2ZONE" of (page 11) is "ON". - When (page 16) is "Bypass". Cleaning the Unit If the faceplate of this unit is stained, wipe it with a dry soft cloth such as a silicon cloth. If the faceplate is stained badly, wipe the stain off with a cloth moistened with neutral cleaner, then wipe it again with a clean soft dry cloth. • Applying spray cleaner directly to the unit may affect its mechanical parts. Wiping the faceplate with a hard cloth or using a volatile liquid such as thinner or alcohol may scratch the surface or erases characters. Cleaning the Faceplate Terminals If the terminals on the unit or faceplate get dirty, wipe them with a clean soft dry cloth. English | 5