Kenwood MP928 Instruction Manual - Page 4

Safety precautions 2WARNING To prevent injury or fire, take the following precautions: • To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. • Never watch the G-Analyzer Display screen when you are driving. Otherwise, a car accident may result. 2CAUTION To prevent damage to the machine, take the following precautions: • Make sure to ground the unit to a negative 12V DC power supply. • Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. • Do not place the faceplate or the faceplate case in areas exposed to direct sunlight, excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. • To prevent deterioration, do not touch the terminals of the unit or faceplate with your fingers. • Do not subject the faceplate to excessive shock, as it is a piece of precision equipment. • When replacing a fuse, only use a new fuse with the prescribed rating. Using a fuse with the wrong rating may cause your unit to malfunction. • Do not apply excessive force to the open faceplate or place objects on it. Doing so will cause damage or breakdown. • Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit. About CD players/disc changers connected to this unit KENWOOD disc changers/ CD players released in 1998 or later can be connected to this unit. Refer to the catalog or consult your Kenwood dealer for connectable models of disc changers/ CD players. Note that any KENWOOD disc changers/ CD players released in 1997 or earlier and disc changers made by other makers cannot be connected to this unit. Connecting unsupported disc changers/CD players to this unit may result in damage. Set the "O-N" Switch to the "N" position for the applicable KENWOOD disc changers/ CD players. The functions you can use and the information that can be displayed may differ depending on the models being connected. • You can damage both your unit and the CD changer if you connect them incorrectly. LX-bus connection • The DAB tuner and the HD Radio tuner unit must be connected one at a time. Lens Fogging When you turn on the car heater in cold weather, dew or condensation may form on the lens in the CD player of the unit. Called lens fogging, this condesnation on the lens may not allow CDs to play. In such a situation, remove the disc and wait for the condensation to evaporate. If the unit still does not operate normally after a while, consult your Kenwood dealer. Attach the panel while you are on the vehicle The panel lock arm appears when the panel is removed. Therefore, the panel must be attached while the electrical system of the car is operating. Do Not Load 8 cm (3 in.) CDs in the CD slot If you try to load a 8 cm (3 in.) CD with its adapter into the unit, the adapter might separate from the CD and damage the unit. 4 | English NOTE This Class B digital apparatus complies with Canadian ICES-003.