Kenwood MP928 Instruction Manual - Page 47

... ... In Standby mode Contrast Adjustment Adjusting the display contrast. Display and Setting "Contrast: 1" "Contrast: 4" (Original setting) In Standby mode G-Counter Level set Calibrating G-Point. Setting the level according to the kinds of vehicles. Display "G-Counter: Level 1" "G-Counter: Level 2" "G-Counter: Level 3" Setting Counter is easy to go up. Counter is hard to go up. In Standby mode Display-reversing Setting If no operation is performed for a predetermined period of time, switching between negative and positive display modes takes place automatically. Display-reversing maintains the initial brightness of the display for a long period of time. Display "Display N/P: Auto" "Display N/P: POSI" Setting Auto reverse display Positive display only • Switching between negative and positive display may not take place depending on the displayed mode. In Standby mode Built-in Amp Setting Controlling the built-in amplifier. Turning OFF this control enhances the preout quality. Display "AMP: ON" "AMP: OFF" Setting The built-in amplifier activates. The built-in amplifier deactivates. • In the case of driving situations calling for few accelerations, set the G-Point up to "G-Counter: Level 1". In the case of frequent accelerations, set it up to "GCounter: Level 3". In Standby mode G-Analyzer Reset Resets the value of G-Meter and G-Counter. 1 Select G-Analyzer Reset mode Push the Control knob towards [4] or [¢]. Select the "G-Reset" display. 2 Enter G-Analyzer Reset mode Press the Control knob for at least 1 second. 3 Select the Reset item Push the Control knob towards [FM] or [AM]. "G-Meter Reset": Reset the value of G-Meter. "G-Counter Reset": Reset the value of G-Counter. 4 Reset the value Press the Control knob for at least 2 seconds. "Reset OK" is displayed. 5 Exit G-Analyzer Reset mode Press the [MENU] button. English | 47