Kenwood XD-355 User Manual - Page 19

RADIO OPERATION Tuning 1 2,3, 5,6 1 Press the ON/STANDBY button to turn the power on. 2 Press the TUNER (BAND) button. 3 Press the TUNER (BAND) button to select the desired frequency band. (FM ST, FM or AM) 4 Press the TUNING/TIME (%UP or fiDOWN) but- ton to tune into the desired station. Manual tuning : Press the TUNING/TIME (%UP or fiDOWN) button 4 as many times as required to adjust the frequency shown on the display to the frequency of the de- sired station. Auto tuning : When the TUNING/TIME (%UP or fiDOWN) button is pressed for more than 0.5 second, scanning will start automatically and the tuner will stop at the first receivable broadcast station. Notes : 4 2,3, • When radio interference occurs during auto scan 1 5,6 tuning, auto scan tuning may stop automatically at that point. • If a weak station signal is found during auto scan tuning, the station will be skipped. • To stop the auto tuning, press theTUNING/TIME (%UP or fiDOWN) button again. After use : Press the ON/STANDBY button to enter the standby mode Note : • The last station turned in will be recalled, even after changing the tuning band or the function, or after switching the unit to the standby mode. 5 To receive an FM stereo transmission, press the TUNER (BAND) button so that the "ST." indicator on the display lights up. • " " will light up on the display when an FM broadcast is in stereo. 6 If the FM reception is weak, press the TUNER (BAND) button so that the "ST." indicator goes off. • The reception changes to mono, the sound be- comes clearer. 19 EN