Kenwood XD-355 User Manual - Page 8

PREPARATION FOR USE • Unplug the AC power cord from the AC socket before connecting or disconnecting any component. Speaker connection Connect each speaker wire to the SPEAKERS terminals as shown. Use speakers with an impedance of 6 Ω or more, as lower impedance speakers can damage the unit. Right speaker Left speaker Connect the black wire to the minus (-) terminal, and the red wire to the plus (+) terminal. Caution : • Do not mix the right channel and left channel wiring when connecting the speakers to the unit. The right speaker is the one on the right side when you are facing the front of the unit. Red Black Red • Do not let bare speaker wires touch each other as this may damage the amplifier and/or speak- ers. Black • Do not allow any objects to fall into or to be placed in the bass reflex ducts. • Do not stand or sit on the speakers. If the speakers fall or collapse, you may be injured. System Name XD-355 / XD355 Speaker Model Name LS-N30S For the U.S. Military only CAUTION Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard. ÷ Do not place any objects impairing heat radiation onto the top of unit. For the countries other than the U.S. Military CAUTION Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard. ÷ Do not place any objects impairing heat radiation onto the top of unit. ÷ Leave some space around the unit (from the largest outside dimension including projection) equal to or greater than, shown below. Top panel : 50 cm Side panel : 10 cm Back panel : 10 cm 8 EN