KitchenAid KDTE304LPA Installation Instructions - Page 3
Attach custom panel, Align top edges of panel to door, Install custom panel, Remove the short screws
View all KitchenAid KDTE304LPA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
5. Attach custom panel 6. Align top edges of panel to door 11/2" Align top edges Wooden panel assembly Customer supplied panel Remove 2 short screws and replace with long screws provided Align the studs on the custom wood panel to the keyhole slots on the door assembly. Ensure that all 4 plastic studs are engaged in the keyhole slots. Slide wood panel down until the top surface of the wooden panel is flush with the top of the door. Open the door and align top edges. Use tape to mark a 3/32" drill bit to gauge the hole depth of approximately 11/2" (38 mm). Drill pilot holes into the top corners of the door, using hole in liner as a guide. 7. Install custom panel 8. Remove the short screws Customer supplied panel Align top edges Drill through this hole 13/8" screw Using a Torx T15 screwdriver, install two #8 x 13/8" (long) screws in top corners to secure custom wood panel in place. Align top edges Remove 2 short screws and replace with long screws provided. Customer supplied panel Remove the short screws (4th from top) on either side of the inner door panel. Use tape to mark a 3/32" drill bit to gauge the hole depth of approximately 11/2" (38 mm). Drill 2 pilot holes using the door liner hole as a guide into the panel. Install the 2 remaining long screws. 3