KitchenAid KERS308XSS Use & Care Guide - Page 10
Setting Surface Controls
UPC - 883049215822
View all KitchenAid KERS308XSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Setting Surface Controls Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently. Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements. Do not allow aluminum foil, empty glass/porcelain cookware or ANY material that can melt to make contact with the ceramic cooktop. If these items melt on the cooktop they may damage the ceramic cooktop. Single radiant surface elements To operate a single radiant element: 1. Place correctly sized cookware on single radiant surface element. 2. Press the On/Off keypad on the Electronic Surface Element control until tone sounds. If no heat setting is selected within 6 seconds of pressing the On/Off keypad the control will turn off. 3. Press the High/+ keypad to start at the Hi setting and then press Low/ to scroll down to desired heat setting, or press the Low/ keypad to start at the Lo setting and press High/+ to scroll up to the desired heat setting (Fig 1). 4. When cooking is complete, press the On/Off keypad to turn the radiant surface element OFF before removing the cookware. Dual radiant surface element To operate a dual radiant element: 1. Place correctly sized cookware on dual radiant surface element. 2. Press the On/Off keypad on the Electronic Surface Element control until tone sounds. If noheat setting is selected within 6 seconds of pressing the On/Off keypad the control will turn off. 3. Press the High/+ keypad to start at the Hi setting and then press Low/ to scroll down to desired heat setting, or press the Low/ keypad to start at the Lo setting and press High/+ to scroll up to the desired heat setting. 4. Press the Burner Size keypad to toggle between one (Fig. 2) or two (Fig. 3) elements. 5. When cooking is complete, press the On/Off keypad to turn the radiant surface element OFF before removing the cookware. Fig. 1 Fig. 2 Fig. 3 Heating with inner (small) element only Heating with both elements Heated areas are shown darkened. 10