Kodak I260 User Guide - Page 19
If you are installing the scanner on a computer that is running, up for at least three minutes. - scanner windows 7
UPC - 041771844417
View all Kodak I260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
4. Plug the power cord into a power outlet. NOTE: Make sure that the power outlet is located within 1.52 metres (5 feet) of the scanner and is easily accessible. 5. Press the side labeled "I" on the power switch to power up the scanner. After you power up the scanner, the red and green indicator lights will illuminate. After approximately one minute, both lights go out. When the green indicator light comes back on, the scanner is installed and ready to begin scanning. However, the host computer may require a few more seconds to detect the scanner. For best calibration and scanning results, allow the scanner lamps to warm up for at least three minutes. • If you are installing the scanner on a computer that is running Windows 2000, the following screen may appear. Select Yes. Kodak has successfully tested the i200 Series Scanners with Windows 2000. Your scanner is now installed. • If you are installing the scanner on a computer that is running Windows XP, the following screen may appear. A-61167 April 2005 15