Konica Minolta Kodak i3450 User Guide - Page 43
Replacing the pre- separation pad, Replacing the background strip(s)
View all Konica Minolta Kodak i3450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Replacing the preseparation pad Change the pre-separation pad when the frequency of multi-fed documents increases. 1. Open the scanner cover. 2. Remove the pre-separation pad by lifting the pad up and out of position. Replacing the background strip(s) 3. Install the new pre-separation pad. Be sure it snaps into place. 4. Close the scanner cover. In the rare case that you may need to replace the background strip(s), follow the procedures below. 1. Open the scanner cover. 2. Lift the tab on the left side of the upper background strip and slide the background strip to the left while lifting it out of position. 3. Insert the new background strip by aligning the tabs with the slots and slide it to the right until it snaps into place. 4. Repeat Steps 2 and 3 to replace the lower background strip. NOTE: When replacing the lower background strip, the tab is now on the right and the strip slides to the right. 5. Close the scanner cover. A-61771 September 2016 37