Kyocera FS C5020N FS-C5020/C5030 Operation Guide (Advanced Edition) - Page 58
Changing Serial Interface Parameters, Interface, Parallel, Serial
View all Kyocera FS C5020N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Using the Operator Panel 8 Press U or V to scroll through the following communication modes: • Nibble (high) • Auto • Normal • High Speed 9 When the desired communication mode is displayed, press [ENTER]. 10 Press [MENU] to exit the menu selection. Changing Serial Interface Parameters NOTE: This section applies to the printer having the optional serial interface board kit (IB-11) installed. You can confirm or change the serial interface parameters including baud rate, data bits, stop bits, parity, and protocol. These parameters must match those of the computer's serial interface. 1 Press [MENU]. 2 Press U or V repeatedly until Interface > appears. 3 If the interface is other than serial, press [ENTER]. A blinking question mark (?) appears. Interface ? Parallel 4 Press U or V repeatedly until Serial appears. Interface ? Serial 5 Press [ENTER] again. 6 Press Z. One of the following serial parameters is indicated (Baud rate for example). 2-30 ADVANCED OPERATION GUIDE