LG LDPS6762S Owners Manual - Page 16

Then twist on the provided wire nuts

Get LG LDPS6762S PDF manuals and user guides View all LG LDPS6762S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

16 INSTALLATION NOTE • The best location for the electrical conduit is on the right side of the back wall. Re-route the electrical cable before installation if the electrical conduit pipe is longer than 3" (76 mm) and is centered on the back wall. 1 Turn off electrical power to the unit at the circuit breaker. 2 Use a Phillips screwdriver to remove the screw from the junction box cover and remove the cover. 6 Insert the electrical cable through the hole in the strain relief. Tighten 2 screws to secure the cable. 3 Use a Phillips screwdriver to remove 2 screws a. 7 Pull the existing wires through the openings in the junction box. Tighten 2 screws d to reassemble the junction box in the appliance. 4 Remove the junction box from the appliance. 8 Pair the white, black, and green wires to the matching colored wires from the dishwasher. Then twist on the provided wire nuts e tightly to connect the corresponding wires. 5 Insert a strain relief b through the hole in the junction box. Tighten the ring nut c to secure it in place.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
16
INSTALLATION
NOTE
•
The best location for the electrical conduit is on
the right side of the back wall. Re-route the
electrical cable before installation if the electrical
conduit pipe is longer than 3” (76 mm) and is
centered on the back wall.
1
Turn off electrical power to the unit at the
circuit breaker.
2
Use a Phillips screwdriver to remove the
screw from the junction box cover and
remove the cover.
3
Use a Phillips screwdriver to remove 2 screws
a
.
4
Remove the junction box from the appliance.
5
Insert a strain relief
b
through the hole in the
junction box. Tighten the ring nut
c
to secure
it in place.
6
Insert the electrical cable through the hole in
the strain relief. Tighten 2 screws to secure
the cable.
7
Pull the existing wires through the openings
in the junction box. Tighten 2 screws
d
to
reassemble the junction box in the appliance.
8
Pair the white, black, and green wires to the
matching colored wires from the dishwasher.
Then twist on the provided wire nuts
e
tightly
to connect the corresponding wires.