Lantronix C6310-3340 C6310-3340 and S6310-3340 User Guide Rev A - Page 11

Installing the Chassis Model C6310

Get Lantronix C6310-3340 PDF manuals and user guides View all Lantronix C6310-3340 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Lantronix x6310 ION POTS Media Converter User Guide Installing the Chassis Model (C6310) The C6310 is a slide-in module that can only be installed in a Lantronix ION chassis (ION001-x, ION106-x, and ION219-x). This section describes how to install the C6310 in the ION chassis. Caution: Failure to wear a grounding device and observe electrostatic discharge precautions when installing the C6310 could result in damage or failure of the module. Chassis Installation Important: The C6310 slide-in cards are "hot swappable" devices and can be removed and installed with chassis power on. 1. Locate an empty slot in the ION System chassis. 2. Grasp the edges of the card by its front panel. 3. Align the card with the upper and lower slot guides, and carefully insert the card into the slot. 4. Firmly seat the card against the chassis back panel. 5. Push in and rotate clockwise the panel fastener screw to secure the card to the chassis (see Chassis Installation figure above). 6. Note that the card's Power LED lights. 33818 Rev. A https://www.lantronix.com/ Page 11 of 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
Lantronix
x6310 ION POTS Media Converter User Guide
33818 Rev. A
Page
11
of
39
Installing the Chassis Model (C6310)
The C6310 is a slide-in module that can only be installed in a Lantronix ION chassis (ION001-x, ION106-x, and
ION219-x). This section describes how to install the C6310 in the ION chassis.
Chassis Installation
Important
:
The C6310 slide-in cards are “hot swappable” devices and can be removed and installed with chassis
power on.
1.
Locate an empty slot in the ION System chassis.
2.
Grasp the edges of the card by its front panel.
3.
Align the card with the upper and lower slot guides, and carefully insert the card into the slot.
4.
Firmly seat the card against the chassis back panel.
5.
Push in and rotate clockwise the panel fastener screw to secure the card to the chassis (see Chassis
Installation figure above).
6.
Note that the card’s Power LED lights.
Caution
: Failure to wear a grounding device and observe electrostatic discharge precautions when
installing the C6310 could result in damage or failure of the module.