Lantronix C6310-3340 C6310-3340 and S6310-3340 User Guide Rev A - Page 16

Lantronix x6310 ION POTS Media Converter User Guide CLI Commands General This section describes the Command Line Interface (CLI) commands available for x6310 operations. These commands are for experienced network administrators who are responsible for configuring and maintaining the ION system. The CLI offers the most comprehensive set of management features. The CLI is used during the initial setup (set ip, etc.) and troubleshooting, but can also be used for day-to-day management (device management, firmware upgrades, managing security features, etc.). Note: CLI commands are case sensitive. Enter the CLI commands as shown. To execute the commands described in this manual, you must press the Enter key after the command has been entered. Command Line Editing This section describes how to enter CLI commands. A CLI command is a series of keywords and arguments. Keywords identify a command, and arguments specify configuration parameters. Display Similar Commands At the command line, you can use the key or the ? key to show available commands in a category of commands after entering a part of the command. For example, use the key to enter part of the command (show ether in this example) to display all of the available commands that start with show ether. The commands display in a single row. C1|S7|L1D>show ether config loopback security statistics tdr Use the ? key after a partial CLI command entry to display all of the available commands that start with show ether, but in a single column: C1|S7|L1D>show ether ? config Partial Keyword Lookup If you terminate a partial keyword with a question mark, alternatives that match the initial letters are provided. (Remember to not leave a space between the command and question mark.) For example, "s?" shows all the keywords starting with "s." 33818 Rev. A https://www.lantronix.com/ Page 16 of 39