Lenovo NetVista Hardware Maintenance Manual (HMM) for NetVista 2292, 6343, 634 - Page 61
Timeout/Parity
View all Lenovo NetVista manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Diagnostic Error Code FRU/Action 011-000-XXX Serial port Interface Test Passed 1. No action 011-001-XXX Serial port Presence 1. Remove external serial device, if present 2. Run setup, enable port 3. System board 011-002-XXX 011-003-XXX Serial port Timeout/Parity error 1. System board 011-013-XXX 011-014-XXX Serial port Control Signal/Loopback test failure 1. System board 011-015-XXX Serial port External Loopback failure 1. Wrap plug 2. System board 011-027-XXX Serial port Configuration/Setup error 1. Run Setup, enable port 2. Flash the system 3. System board 011-03X-XXX 011-04X-XXX Serial port failure 1. System board 011-195-XXX Serial port Test aborted by user 1. Information 2. Re-start the test, if necessary 011-196-XXX 1. Press F3 to review the log file Serial port test halt, error threshold exceeded 2. Re-start the test to reset the log file 011-197-XXX Serial port test warning 1. Make sure the component that is called out is connected and/or enabled 2. Re-run test 3. Component that is called out in warning statement 4. Component under test 011-198-XXX Serial port test aborted 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test 3. Go to the ″Undetermined problems″ section 011-199-XXX Serial port test failed, cause unknown 1. Go to the ″Undetermined problems″ section 2. Flash the system and re-test 3. Replace component under function test 011-2XX-XXX Serial port signal failure 1. External serial device 2. System board 014-000-XXX Parallel port Interface Test Passed 1. No action Chapter 7. Symptom-to-FRU index 55