Lenovo Q200 Q200 Hardware Replacement Guide - Page 16

top of the chassis. 4. Refer to the "Completing the installation". Replacing a memory module Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://www.lenovo.com/support. To replace a memory module: 1. Open the computer cover. Refer to "Opening the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Pivot the drive bay assembly upward to gain access to the system board. 3. Locate the memory module connectors. Refer to "Locating components". 4. Remove the memory module being replaced by opening the retaining clips as shown. 5. Position the new memory module over the memory connector. Make sure the notch on the memory aligns correctly with the connector key on the system board. Push the memory module straight down into the connector until the retaining clips close. 31032756_HaWaii-HRG_EN.indd 13 Hardware Replacement Guide 13 2008.1.8 3:31:32 PM