Lenovo Q200 Q200 Hardware Replacement Guide - Page 31

16. Install the heat sink and fan assembly on the system board. 17. Connect the heat sink and fan assembly cable to the system board. Refer to the "Identifying parts on the system board". 18. Install the system board into the chassis and allign the screw holes with those in the chassis.Insert and tighten the screws that secure the system board. Refer to the "Replacing the system board". 19. Reconnect the disconnected cables to the system board. 20. Refer to the "Completing the installation". Replacing the hard disk drive Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://www.lenovo.com/support. Important When you receive a new hard disk drive, you will also receive a set of Operating System Recovery CD. The set of Operating System Recovery CD will enable you to restore the Operating System of the hard disk. For more information on recovering factory-installed software, refer to "OneKey Recovery" in the User Guide. To replace the hard disk drive: 1. Open the computer cover. Refer to "Opening the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Pivot the drive bay assembly upward to gain access to the system board. 28 Hardware Replacement Guide 31032756_HaWaii-HRG_EN.indd 28 2008.1.8 3:31:39 PM