Lenovo S310 Lenovo S310 All-In-One Hardware Maintenance Manual - Page 117
Replacing the integrated camera
View all Lenovo S310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Figure 39. Removing the internal speakers 8. Route the new internal speaker cables, and then position the new internal speakers on the front bezel so that the two screw holes in each internal speaker align with those in the front bezel. 9. Reinstall the two screws to secure each of the internal speakers to the front bezel. 10. Connect the internal speaker cables to the system board. See "System board parts and connectors" on page 82. 11. Reinstall the system board shield. See "Removing and reinstalling the system board shield" on page 96. 12. Go to "Completing the parts replacement" on page 121. Replacing the integrated camera Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty, and Setup Guide, go to: http://www.lenovo.com/support This section provides instructions on how to replace the integrated camera. Note: The integrated camera is available only in some models. To replace the integrated camera, do the following: 1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer. 2. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up. 3. Remove the computer cover. See "Removing the computer cover" on page 89. 4. Locate the integrated camera in the computer. See "FRU locations" on page 80. 5. Remove the system board shield. See "Removing and reinstalling the system board shield" on page 96. 6. Note the routing of the integrated camera cable, and then disconnect the cable from the system board. See "System board parts and connectors" on page 82. 7. Press the two plastic tabs 1 that secure the integrated camera to the front bezel to remove the integrated camera from the computer. Chapter 8. Replacing FRUs 111