Lenovo S310 Lenovo S310 All-In-One Hardware Maintenance Manual - Page 92

Removing and reinstalling the foot stands

Get Lenovo S310 PDF manuals and user guides View all Lenovo S310 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 92 highlights

5. Reinstall the system stand hinge cover. See "Removing and reinstalling the system stand hinge cover" on page 82. Removing and reinstalling the foot stands Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty, and Setup Guide, go to: http://www.lenovo.com/support This section provides instructions on how to remove and reinstall the foot stands. CAUTION: Turn off the computer and wait three to five minutes to let the computer cool before removing the foot stands. To remove and reinstall the foot stands, do the following: 1. Remove any media from the drives and turn off all attached devices and the computer. 2. Disconnect all power cords from electrical outlets. 3. Disconnect the power cords, Input/Output cables, and any other cables that are connected to the computer. See "Locating connectors, controls, and indicators on the front of your computer" on page 77 and "Locating connectors on the rear of your computer" on page 79. 4. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up. 5. Remove the rubber piece from each foot stand. Figure 10. Removing the rubber piece from each foot stand 6. Remove the screw that secures each foot stand, and then remove each foot stand from the computer. 86 Lenovo S310 All-In-OneHardware Maintenance Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
5. Reinstall the system stand hinge cover. See “Removing and reinstalling the system stand hinge cover”
on page 82.
Removing and reinstalling the foot stands
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the
Safety, Warranty, and Setup Guide
that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide
, go to:
This section provides instructions on how to remove and reinstall the foot stands.
CAUTION:
Turn off the computer and wait three to five minutes to let the computer cool before removing the
foot stands.
To remove and reinstall the foot stands, do the following:
1. Remove any media from the drives and turn off all attached devices and the computer.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cords, Input/Output cables, and any other cables that are connected to the
computer. See “Locating connectors, controls, and indicators on the front of your computer” on page
77 and “Locating connectors on the rear of your computer” on page 79.
4. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
5. Remove the rubber piece from each foot stand.
Figure 10. Removing the rubber piece from each foot stand
6. Remove the screw that secures each foot stand, and then remove each foot stand from the computer.
86
Lenovo S310 All-In-OneHardware Maintenance Manual