Lenovo ThinkCentre M90z Hardware Maintenance Manual for ThinkCentre M90z - Page 60

Diagnostic Error Code 025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface failure 025-195-XXX IDE interface Test aborted by user 025-196-XXX IDE interface test halt, error threshold exceeded 025-197-XXX IDE interface test warning 025-198-XXX IDE interface test aborted 025-199-XXX IDE interface test failed, cause unknown 030-000-XXX SCSI interface Test Passed 030-00X-XXX 030-01X-XXX SCSI interface failure 030-027-XXX SCSI interface Configuration/Setup error 030-03X-XXX 030-04X-XXX SCSI interface error 030-195-XXX SCSI interface Test aborted by user FRU/Action 1. IDE signal cable 2. Check power supply. 3. Reseat IDE signal cable. 4. IDE device 5. System board Information only Restart the test, if necessary. 1. Press F3 to review the log file. 2. Restart the test to reset the log file. 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 39. 2. Re-run test. 3. Replace the component that is called out in warning statement. 4. Replace the component under test. 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 39. 2. Flash the system and re-test. See "Flash update procedures" on page 273. 3. Go to "Undetermined problems" on page 64. 1. Go to "Undetermined problems" on page 64. 2. Flash the system and re-test. See "Flash update procedures" on page 273. 3. Replace component under function test. No action 1. SCSI signal cable 2. Check power supply 3. SCSI device 4. SCSI adapter card, if installed. 5. System board 1. SCSI signal cable 2. Flash the system. See "Flash update procedures" on page 273. 3. SCSI device 4. SCSI adapter card, if installed. 5. System board 1. SCSI signal cable 2. Check power supply 3. SCSI device 4. SCSI adapter card, if installed. 5. System board Information only Restart the test, if necessary. 54 ThinkCentre Hardware Maintenance Manual