Lenovo ThinkPad L430 (English) User Guide - Page 134
Startup menu, Startup, Attention, Changing the startup sequence, Network
View all Lenovo ThinkPad L430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
Table 5. Security menu items (continued) Menu item Submenu item Computrace Selection • Disabled • Enabled • Permanently Disabled Comments The Intel anti-theft suspend screen will be displayed at next boot to enter the suspend mode. Enable or disable the UEFI BIOS interface to activate the computrace module. Computrace is an optional monitoring service from Absolute Software. Note: If you set the computrace module activation to Permanently Disabled, you will be unable to enable this setting again. Startup menu To change the computer startup settings, select Startup from the ThinkPad Setup main menu. Attention: • After you change your startup sequence, you must be extremely careful not to specify a wrong device during a copy, a save, or a format operation. If you specify a wrong device, your data and programs might be erased or overwritten. • If you are using the BitLocker drive encryption, you should not change the startup sequence. BitLocker drive encryption detects the change of startup sequence and locks the computer from booting. Changing the startup sequence To change the startup sequence, do the following: 1. Select Boot or Network, then press Enter. The default boot list is displayed, showing the order in which devices will be started up. Even devices that are not attached to or installed on your computer are listed. • Use the Boot submenu to specify the startup sequence that runs when you turn on the power. • Use the Network submenu to specify the startup sequence that runs when Wake on LAN is enabled. Wake on LAN is commonly used by LAN administrators in corporate networks to get remote access to your computer. 2. Set the startup sequence by using the following keys: • Use cursor keys to select a device. • Use F6 or the combination of Shift and + to move the device up to a higher priority. • Use F5 or - to move the device down to a lower priority. • Use the combination of Shift and ! to exclude or include a device. 3. Press F10 to save the changes and restart the system. To change the startup sequence temporarily so that the system starts up from a different drive, do the following: 1. Turn off the computer. 116 User Guide