Lenovo ThinkStation E30 Hardware Maintenance Manual - Page 61
Audio port Interface Test Passed - raid
View all Lenovo ThinkStation E30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Diagnostic Error Code 030-196-XXX SCSI interface test halt, error threshold exceeded 030-197-XXX SCSI interface test warning 030-198-XXX SCSI interface test aborted 030-199-XXX SCSI interface test failed, cause unknown 035-000-XXX RAID interface Test Passed 035-0XX-XXX RAID interface Failure 035-195-XXX RAID interface Test aborted by user 035-196-XXX RAID interface test halt, error threshold exceeded 035-197-XXX RAID interface test warning 035-198-XXX RAID interface test aborted 035-199-XXX RAID interface test failed, cause unknown 071-000-XXX Audio port Interface Test Passed FRU/Action 1. Press F3 to review the log file. 2. Restart the test to reset the log file. 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 37. 2. Re-run test. 3. Replace the component that is called out in warning statement. 4. Replace the component under test. 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 37. 2. Flash the system and re-test. See "Updating (flashing) the BIOS" on page 169. 3. Go to "Undetermined problems" on page 65. 1. Go to "Undetermined problems" on page 65. 2. Flash the system and re-test. See "Updating (flashing) the BIOS" on page 169. 3. Replace component under function test. No action 1. RAID signal cable 2. RAID device 3. RAID adapter card, if installed 4. System board Information only Restart the test, if necessary. 1. Press F3 to review the log file. 2. Restart the test to reset the log file. 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 37. 2. Re-run test. 3. Replace the component that is called out in warning statement. 4. Replace the component under test. 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 37. 2. Flash the system and re-test. See "Updating (flashing) the BIOS" on page 169. 3. Go to "Undetermined problems" on page 65. 1. See "Undetermined problems" on page 65. 2. Flash the system and re-test. See "Updating (flashing) the BIOS" on page 169. 3. Replace component under function test. No action Chapter 8. Symptom-to-FRU Index 55