Lexmark C772N Service Manual - Page 79
xx paper jam service check, compensa, tor pick, assembly, removal on, HCIT
UPC - 734646047227
View all Lexmark C772N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
5061 Step 7 Actions and questions Make sure the pass thru sensor is correctly connected to the Tray x system board. Is the sensor cable connected correctly? 8 Check the autocompensator cable for correct installation to Tray x system board. Is the cable connected correctly? Yes Replace the FRUs in the following order: 1. Pass thru sensor assembly. 2. Electronics/ size sensing assembly with system board. Replace the option, or replace the following parts in the order until the error is cleared: • Autocompensator pick assembly. See "Autocompensator pick assembly removal" on page 4-27. • Tray x system board. No Install the cable correctly. Install the cable correctly. 242.xx paper jam service check For second installed tray/option. 500-sheet drawer option Media does not reach the pass thru sensor. Step 1 Actions and questions Is Tray 2 a HCIT 2000-sheet option? 2 Make sure the media installed in the tray meets specifications. Does the media meet specifications? 3 Make sure the media is loaded correctly. Make sure the side and back restraints are located and seated properly. Is the media loaded correctly? Yes Go to "HCIT" on page 2-39 Go to step 3 Go to step 4 No Go to step 2 Inform the customer that media loaded in Tray x does not meet media specifications. Load the media correctly. Diagnostic information 2-37