Lexmark E260 Service Manual - Page 101
Adjustment procedures, Printhead assembly mechanical adjustment
View all Lexmark E260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
4513-200, -220, -230 Adjustment procedures Printhead assembly mechanical adjustment Note: The printhead must be aligned electronically. To align the printhead electronically, call the next level of support. Speical files and a computer are required to electronically align the unit. A printhead needs to be correctly positioned after it has been removed. Use a pencil to mark the screw locations of the old printhead on the metal frame. Align the new printhead relative to the location of the old printhead. Skew is caused by a sheet being fed through the printer while misaligned. The entire image is rotated relative to the sheet edges. However, a mechanically misaligned printhead causes the horizontal lines to appear skewed while the vertical lines remain parallel to the vertical edges.There are no adjustments for skew. Check the pick roll (paper pick assembly) for wear, the paper path for obstructions, the fuser for proper setting, and the tray paper guides for fit to the media. Paper feed skew Printhead (mechanical) alignment To adjust the printhead: 1. Enter the Diagnostics Menu. See "Diagnostics mode selections" on page 3-8. 2. Press and release to go to Cont Prt Simplex Tray 1 ( is on). 3. Press and hold to print the first Cont Prt Simplex Tray 1 test page. Press immediately after the paper picks to avoid printing more pages. 4. Fold the printed test page on the left side so that a few millimeters of grid lines wrap around the outside of the fold. See photo below. 5. Fold a second vertical fold near the center so that the left side top edge aligns with the right side top edge. Diagnostic aids 3-9