Lexmark E260 Service Manual - Page 68

4513-200, -220, -230 Service error codes Service error codes are generally non-recoverable except in an intermittent condition when the printer can be put into POR to temporarily recover from the error condition. Service error codes (9xx) Error Description Action Engine software service errors 902.xx Engine software error DC pick motor errors 914.00 DC pick motor error Replace the controller board. See "Controller board service check" on page 2-51 914.01 Lost encoder feedback Transfer service errors 917.xx Transfer service error Fuser service errors 920.00 Under temperature during steady state control. 920.01 Fuser took too long to heat up after transitioning to new enhanced mode. Replace the transfer roll. See "Transfer roll service check" on page 2-65. Replace the fuser. See "Fuser service check" on page 2-53. 920.02 920.03 Fuser fell too far below desired temperature while printing. Fuser too cool while checking for slope change. 920.04 920.05 Fuser too cool when heating to desired temperature after slope change. Fuser under temperature while printing 920.06 Fuser under temperature while printing 920.07 Fuser under temperature while printing 920.08 Fuser temperature did not increase after IR recovery. 920.20 921.00 Belt fuser under temperature during steady state control. This can occur in printing or standby modes. Under temperature during standby control. 921.01 922.00 Fuser temperature did not reach standby temperature after two attempts Fuser failed to ramp to target temperature 922.01 922.02 922.03 Fuser did not reach standby temperature in time (standby control) Hot roll took too long to reach the beginning lamp detection temperature. Hot roll reached final lamp detection temperature, but took longer than largest time in lookup table. 922.04 Hot roll timed out in trying to reach the final lamp detection temperature. 2-42 Lexmark™ E260, E260d, E260dn