Lexmark E260 Service Manual - Page 70
-220, Transport motor service errors, Error, Description, Action, Printhead service - e260dn configuration page
View all Lexmark E260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
4513-200, -220, -230 Service error codes (9xx) (Continued) Error Description Action 931.01 932.00 No first hsync Lost hsyncs Replace the printhead. See "Printhead service check" on page 2-65. 932.01 Lost hsyncs 933.01 934.00 Printhead boost signal failure Mirror motor lost lock. 934.01 Mirror motor lost lock. 935.00 No initial mirror motor lock 935.01 Timed out waiting for mirror motor lock 935.10 Printhead sweep error, swept through Hz range without finding the resonant frequency 935.12 Printhead sweep error, coarse sweep state 935.15 935.16 Printhead open-loop error, check prelim amp state Printhead open-loop error, enable amp Kp state 935.17 Printhead closed-loop error, amp Kp failed to converge 935.18 935.19 Printhead closed-loop error, enable amp Ki state Printhead closed-loop error, amp Ki failed to converge 935.20 935.21 Printhead closed-loop error, enable offset controller state Printhead closed-loop error, load scan regs state 935.22 935.23 Printhead closed-loop error, fwd and rev capture times differ by too much Printhead closed-loop error, check sweep accuracy state 935.25 Printhead closed-loop error, off-resonant PI effort state 935.26 Timed out on POR sweep 935.27 Exceeded maximum open loop drive level when configuring for sweep re-try. 935.28 Exceeded maximum open loop drive level when setting operating Hz. Transport motor service errors 936.01 No lock detected at normal motor start 936.02 No lock detected at motor start for motor ID Replace the main motor gear drive. See "Main motor service check" on page 2-54 936.03 No halls detected at motor start 936.04 Failed to stop within timeout 936.05 Stall detected during speed control 2-44 Lexmark™ E260, E260d, E260dn