Lexmark OptraImage SC 1275 Service Manual - Page 68
Lexmark OptraImage SC 1275 Manual
View all Lexmark OptraImage SC 1275 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Service Checks Fuser Service Check FRU 1 • Heater Lamp (H1) • Thermostat (S4) • Power Unit (PU1) • Mechanical Controller Board (PWB-A) Action Be sure the heater lamp (H1) lights up when the power is turned on. (Open the rear door and activate the rear door interlock to see the fuser lamp.) If the lamp does not light up, check for voltage between CN2PU-1 and CN2PU-3 of the power unit (PU1). If there is voltage, replace the heater lamp (H1) or the thermostat (S4). If there is no voltage, replace the power unit (PU1) or the mechanical controller board (PWB-A). 2 • Fuser • Mechanical Controller Board (PWB-A) • Fuser • Mechanical Controller Board (PWB-A) Check for voltage between CN9A-6 and CN9A-7 of thermistor 1 (TH1). If there is no voltage, replace the fuser. If there is voltage, replace the mechanical controller board (PWB-A). Check for voltage between CN9A-8 and CN9A-9 of thermistor 2 (TH2). If there is no voltage, replace the fuser. If there is voltage, replace the mechanical controller board (PWB-A). 3 Diagnostic Information 2-33