LiftMaster 8365-267 8365-267 Owners Manual - Page 27
Control Panel Setup, Activate, LIGHT, LIGHT FEATURE Default is Active, MAINTENANCE ALERT SYSTEM MAS
View all LiftMaster 8365-267 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Operation Control Panel Setup LOCK NOTE: Your remote controls will NOT work when LOCK mode is active however your keyless entry will still allow access to your garage. Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time. Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume. Command LED LOCK Button LIGHT To change the amount of time the garage door opener lights will stay on: Press and hold the LOCK button until the garage door opener lights flash.* The time interval is indicated by the number of flashes. Number of times garage door opener lights flash Time the garage door opener light stays on 1 1 1/2 Minutes 2 2 1/2 Minutes 3 3 1/2 Minutes 4 4 1/2 Minutes To cycle through the time intervals repeat the step above. * Approximately 10 seconds LIGHT FEATURE (Default is Active) Deactivate: Press and hold the LIGHT button until the garage door opener lights turn on, then off again.* Activate: Start with the garage door opener lights on. Press and hold the LIGHT button until the garage door opener lights turn off, then on again.* NOTE: If the command LED is continuously blinking, the LOCK feature needs to be deactivated. LOCK Button LIGHT Button MAINTENANCE ALERT SYSTEM (MAS): Activate/Deactivate Press and hold the LEARN button. Then press the LIGHT button. The service LED will flash the status; Active is 2 flashes and deactivated is 3 flashes. Service LED LEARN Button LIGHT Button Command LED 26