LiftMaster ATS ATS2113X Manual - Page 5

Carton Inventory Your garage door opener is packaged in two cartons which contain the motor unit and all parts illustrated below. Accessories will depend on the model purchased. If anything is missing, carefully check the packing material. Parts may be stuck in the foam. Hardware for installation is also listed below. Mounting Hardware (Rail Support Bracket) "C" Wrap (2) Rail Support Bracket Lighted Door Control Button 2-Conductor Bell Wire White & White/Red Door Bracket Door Bracket Plate Curved Door Arm Safety Reversing Sensor Mounting Bracket With Slot (2) Chain Header Bracket with Clevis Pin and Fastener Styrofoam Safety Reversing Sensor Mounting Bracket With Square Holes (2) Rail Motor Unit Straight Door Arm Chain Pulley Bracket Trolley Safety Labels and Literature The Protector System® (2) Safety Reversing Sensors (1 Sending Eye and 1 Receiving Eye) with 2-Conductor White & White/Black Bell Wire attached HARDWARE INVENTORY Assembly Hardware Washered Bolt, 5/16"-18x1/2" (2) (Mounted in Opener) Hex Screw 1/4"-20x5/8" (2) Lock Washer 1/4"-20x5/8" (2) Screw #8-32x3/8" (1) Washered Bolt 5/16"-18x1/2" (2) Installation Hardware Hex Screw 5/16"-18x7/8" (4) Nut 5/16"-18 (4) Lock Washer 5/16" (4) Lag Screw 5/16"-9x1-5/8" (2) Lag Screw 5/16"-18x1-7/8" (2) Screw 6ABx1-1/2" (2) Handle Ring Fastener (3) Self-Tapping Screw 1/4"-14x5/8" (2) Insulated Staples (10) Drywall Anchors (2) Clevis Pin 5/16"x2-3/4" (1) Clevis Pin 5/16"x1" (1) Clevis Pin 5/16"x1-1/4" (1) Rope Hardware for Safety Reversing Sensor Lag Screw 1/4"x1-1/2" (4) Carriage Bolt 1/4"-20x1/2" (4) Lock Nut 1/4"-20 (4) Wing Nut (2) Hex Screw 1/4"-20x1-1/2" (2) Screw #10-32x3/8" (4) Lock Nut #10x32 (4) Insulated Staples (20) 5