LiftMaster MEGA SLIDE-X MEGA SLIDE-X MSLXDCBB Manual
LiftMaster MEGA SLIDE-X Manual
 |
View all LiftMaster MEGA SLIDE-X manuals
Add to My Manuals
Save this manual to your list of manuals |
LiftMaster MEGA SLIDE-X manual content summary:
- LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 1
Radio Receiver Included The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196 www.liftmaster.com Model MSLXDCBB3 (MEGA SLIDE X) 1/2 HP COMMERCIAL DUTY SLIDE GATE OPERATOR OWNER'S MANUAL THIS UNIT IS A CLASS 1, 2, 3, OR 4 SLIDE GATE OPERATOR FOR USE IN SLIDE GATE APPLICATIONS - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 2
BEFORE attempting to install, operate or maintain the operator, you MUST read and fully understand this manual and follow all safety instructions. • DO NOT attempt repair or service of your commercial door and gate operator unless you are an Authorized Service Technician. WARNING Mechanical CAUTION - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 3
coils, 2 required MS202) Warning Signs 2 Sealed 12 Vdc, 7AH Batteries 2 MANUAL RELEASE The MANUAL RELEASE switch is located on the left side of the gate operator frame towards the chain. To operate the gate manually, place the MANUAL RELEASE switch in the down position. This will remove power - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 4
servicing the general public, in which unauthorized access is prevented via supervision by security personnel. SAFETY ACCESSORY SELECTION All UL325 compliant LiftMaster gate operators GATE OPERATOR ENTRAPMENT PROTECTION UL325 Installation Class Class I & II Slide Gate Operator Primary - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 5
Rollers • Vertical Posts • Photoelectric Sensors • Instructional and Precautionary Signage 4. Install the gate operator only when: a. The operator is appropriate for the construction and the usage class of the gate. b. All openings of a horizontal slide gate are guarded or screened from the bottom - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 6
open. Photo beams are to be installed according to their manufacturer's instructions and are to be placed in areas that pose a risk of entrapment. A separate pedestrian door is required per UL-325. It is recommended that all gates and operators be installed to conform to that latest ASTM F2200-02 - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 7
inside and outside of a vehicular horizontal slide gate. Non-contact sensors such as photo eyes must protect during both open and close gate cycles. • Injuries occur when people put their hands and arms through openings in the grill while the gate is operating. They cannot retract their arm and it - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 8
OPERATOR OVERVIEW The LiftMaster model MEGA SLIDE X slide gate operator is unique in the industry. Setting the MEGA SLIDE X apart are many features that as master or second operator. • Safe 24 Vdc low voltage motor and control wiring. • LED diagnostics for easy trouble shooting. • Closing timer - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 9
chain. SAFETY EDGE INSTALLATION See safety page in front of manual It is highly recommended that a pressure sensing edge (safety operator should be cut so that excess cord be eliminated to prevent it from getting tangled in the gate or mechanism. Edges that are to REVERSE and re-open a closing gate - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 10
time the unit may be protected. The location of the power disconnect should be returned to service. visible and clearly labeled. • Disconnecting power at the fuse box BEFORE proceeding. Operator MUST be properly grounded and connected in • ALL power and control wiring MUST be run in separate - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 11
and not continue to close until the close input is removed or gate is re-opened. Terminal 7, Back-Away (For Barrier Arm Gate Only) - This input is recommended for use with our Mega Arm barrier gates. For your Mega Slide X, please use terminals 1, 2 or 3 for your free exit loop input. Terminals - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 12
run to the same terminals of the second. Along with these control wires, both operators MUST share a common ground connection from chassis to chassis (or from PCB common to PCB common (Ex: master gate J5 terminal #12 to second gate J5 terminal #12) EXAMPLE: If only open and close are used at master - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 13
. SWITCH 8: Not used at this time (VER 6.34 or higher only). CLOSE TIMER - SWITCH PACK S2 (1-5) On the MEGA SLIDE X the switches 1-5 on S2 are for the closing timer delay. If S2-7 is on, the gate will auto close by timer. Default is S2-3 "on" to provide a 4 second delay if activated. MODE SELECTIONS - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 14
be made by qualified service personnel. ADJUSTMENT While running the gate open and closed, verify that the gate travels as expected. Verify that the operator reverses off a rigid the setup, a double entrapment condition occurs, refer to the troubleshooting section to rest the gate. 14 L 7 5 6 - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 15
THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following Repeat Steps 2 and 3 for each remote control that will be used to operate the gate. FIGURE 2 TO ERASE ALL REMOTE CONTROL CODES Press and hold the "learn" - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 16
AVERTISSEMENT Service Kits are available for battery replacement. Please contact Technical Support (see manually initiating the battery test. BATTERY HANADLVINEG R/ STTOISRASGEEMENT Refer to the battery manufacturer's Material Safety Data Sheets (01-30839 "MSDS Sheets, Battery, Standard"). LiftMaster - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 17
WARNING electrocution or fire, BEFORE proceeding • Disconnect ac power at the fuse box. • Disconnect dc power at the battery connection. GATE NOT OPERATING Gate will not operate. Is the HBEAT flashing? No Check the battery connections. Check fuse F4. Replace if blown. Yes Yes Is the HBEAT - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 18
the gate's safe operation. RECOMMENDATION 2: Use safety pressure sensing edges to prevent entrapment. RECOMMENDATION 3: Install ALL access control devices within view of gate. Card Reader Tele-entry Radio Control Safety Loop Safety Loop Mega Slide X Safety Loop Open Loop Mega Slide X 18 - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 19
(Pulse Open/Close) Safety Loop Input Close Gate Input - Close Loop Back Away - Free Exit Loop Shadow Loop Commons - 0 Vdc C18 U18 C15 Q6 Q5 Q4 D28 1 1 J2 AUX LIMITS M/S J3 R14 D8 D1Ø R18 S1 S2 1 2345678 1 2345678 R1 R12 R17 R16 MANUAL Q2 OPEN 1 2 3 4 5 6 7 8 9 1Ø 11 12 J5 S3 T2 - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 20
16 13 1 14 8 FRONT VIEW REPAIR PARTS 9 3 5 18 12 2 6 7 20 DCS 1/2 HP 17 11 10 15 17 SIDE VIEW REAR VIEW 3 9 19 4 INDIVIDUAL PARTS ITEM PART # 1 MS001 2 MS003 3 MS005 4 MS006X 5 MS007 6 MS010 7 MS009 8 MS351 9 MS041 10 MS043 11 MS013 12 MS014 13 MS015 14 MS016 15 MS018 16 - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 21
with thermostat Replacement Battery (1): 12V, 7Amp Battery 2 required per operator. K1 Relay Output Option: Accessory relay for external signaling (common surge suppressor, wire jumper, duplex box covers and detailed instructions. Passport 3-Button Remote Control : Includes visor clip. Passport - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 22
AND SERVICE INFORMATION IS AS NEAR AS YOUR TELEPHONE. SIMPLY DIAL OUR TOLL FREE NUMBER: 1-800-528-2806 www.liftmaster.com WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: • PART NUMBER • PART NAME • MODEL NUMBER ADDRESS ORDERS TO: THE CHAMBERLAIN GROUP, INC. Technical Support Group - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 23
to our service center for warranty repair. You will be advised of shipping instructions when you call. Please include a brief description of the problem and a DOES NOT COVER NON-DEFECT DAMAGE, DAMAGE CAUSED BY IMPROPER INSTALLATION, OPERATION OR CARE (INCLUDING, BUT NOT LIMITED TO ABUSE, MISUSE, - LiftMaster MEGA SLIDE-X | MEGA SLIDE-X MSLXDCBB Manual - Page 24
and is clear on proper use of gate operator (required). _____ Customer instructed on proper use of all control devices used with operator. _____ Safety instructions were reviewed and left with customer (required). _____ Installer offered a preventative service/maintenance contract. _____ A photo of
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
Model
MSLXDCBB3
(MEGA SLIDE X)
1/2 HP COMMERCIAL DUTY SLIDE GATE OPERATOR
OWNER’S MANUAL
THIS UNIT IS A CLASS 1, 2, 3, OR 4 SLIDE GATE OPERATOR FOR USE IN SLIDE GATE APPLICATIONS
The Chamberlain Group, Inc.
845 Larch Avenue
Elmhurst, Illinois 60126-1196
www.liftmaster.com
Radio
Receiver
Included