LiftMaster MEGA SLIDE-X MEGA SLIDE-X MSLXDCBB Manual - Page 24

INSTALLATION CHECK OFF LIST This Slide Gate operator is installed for use in a Class _____ installation. Each item on this installation check off list should be verified by the installer. _____ Two warning signs securely installed on each side of gate panel (required). _____ 1 or 2 safety photo beams installed, one across each side of gate opening (required). _____ 1 or 2 stop photo beams installed on each side of fixed gate panel (required). _____ Customer advised that gate in for vehicular traffic only (required). _____ A separate pedestrian entry and/or exit is provided (required). _____ Contact edges installed and functional at all hazard or pinch points. _____ Safety guards installed covering all cantilever wheels (required). _____ All controls located far out of reach of gate, fixed panel and operator (required). _____ This class operator is approved for the application of the operator (1, 2, 3 or 4) (required). _____ A sphere with a 2-1/4" diameter cannot be pushed through the gate or fixed panel. _____ A safety screen/mesh is installed with a minimum height of 4' from ground. _____ Controls intended to reset gate after obstructed installed in line of sight (required). _____ Hard wired contact sensors located and wired to avoid any mechanical damage. _____ Customer instructed and is clear on proper use of gate operator (required). _____ Customer instructed on proper use of all control devices used with operator. _____ Safety instructions were reviewed and left with customer (required). _____ Installer offered a preventative service/maintenance contract. _____ A photo of completed installation taken from front and back of gate and dated. _____ Gate conforms to the recommended ASTM F 2200-02 requirements. Customer's Signature Date Installer's Signature Date Customer and installer should retain a copy of this check off list for their records. 01-60177D © 2008, The Chamberlain Group, Inc. All Rights Reserved