LiftMaster MEGA SLIDE-X MEGA SLIDE-X MSLXDCBB Manual - Page 11
INPUT COMMANDS CONNECTIONS, Input Commands - J5 Connector Block at top of Control Board
View all LiftMaster MEGA SLIDE-X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
INPUT COMMANDS CONNECTIONS (Use common and normally open contacts from devices connected to these inputs) JP2 Input This input will stop the gate and activate the siren. This input is for connection to wired contact edge sensors at pinch points and photo beams that run along either side the gate panel when in open position (if dead panel is present one beam should run along it). Input Commands - J5 Connector Block at top of Control Board Control wire connections at low voltage terminal strip will be at the top of the electronic control board. Make connections to the appropriate points for the desired operation. Wires should be UL approved 600 volt rated and at least 18 awg. All external control devices must have normally open dry contacts. DO NOT CONNECT ANY DEVICE WHICH WOULD DELIVER ANY VOLTAGE OF ANY KIND TO THESE TERMINALS. Terminals 9, 10, 11, 12 are the commons (0 Vdc) used to activate the following inputs. Terminal 5, Safety - Safety edge(s) and safety loop input. This function will make the gate reverse and go back to the open position if it was closing. Input is for all NORMALLY OPEN contact safety devices. This input is disabled when gate is in the full closed position. Use with vehicle loops, photo beams and sensors. Terminal 6, Close - ANTI-TAIL GATE close input. When using a vehicle detector, you must use the presence contacts (N.O. and C.) This input will QUICK close gate after input is applied and then removed. It will stop the open cycle and reverse gate to close. (Example: Car crosses over close loop before gate reaches full open position - gate will reverse and close). NOTE: The close input also acts as a safety-stop in that if gate is closing and a tail-gater is sensed at the close input, the gate WILL STOP its closing motion and not continue to close until the close input is removed or gate is re-opened. Terminal 7, Back-Away (For Barrier Arm Gate Only) - This input is recommended for use with our Mega Arm barrier gates. For your Mega Slide X, please use terminals 1, 2 or 3 for your free exit loop input. Terminals 1, 2, 3 Open - These inputs will trigger gate open when pulsed or hold gate open with maintained contact. When released gate will close if closing timer is on or if close input is given. Terminal 4, Auxiliary Open - This is the wired line of sight, intended manual reset input. Use this input to reset the unit after a 2nd sequential obstruction is sensed and gate is locked with siren running. This input normally functions as listed below. Terminal 8, Shadow Loop - This input operates as a hold open only when gate is a full open position. Terminals 9, 10, 11, 12 Common - These inputs used for common (0 Vdc) to above listed functions. NOTE: J5 inputs 1-8 are tied to LED indicators to assist in trouble shooting. 3-Button Control Station - Not already in place. See diagram below. Acts same as 1, 2, 3 above with S2-6 off. With S2-6 ON this will operate as a pulse-open, pulse-close. NOTE: Pulse to close will only work when gate is at full open position. SIREN will run for 5 minutes after 2nd sequential obstruction, then turns itself off, however operator will require a reset signal to J5 #4 to re-activate gate. In addition, cycling the ac power Open Close Stop will also reset unit. J5 Input #1 J5 Input #6 JP2 Connector (NOTE: Siren will sound when stop button is depressed) J5 Commons #9-12 11