Linksys LNE100TX User Guide - Page 20

Linksys Instant EtherFast® Series 13. A Logon window will appear, requiring you to enter a User name and Password. Make up a user name and password (if you haven't already) and click the OK button. Do not click the Cancel button or press the Escape key. Clicking either of these buttons will prevent you from logging into the network. If the logon does not appear or if it does not allow you to log on, refer to the Troubleshooting section. 14. Once you are at the Windows Millennium desktop, double-click the My Network Places icon, the Entire Network icon, and then the Your WorkGroup icon. You should see one icon for the entire network and the names of the other PCs on the network. • If you can see your computer along with all the other computers on the network in Network Neighborhood, then the Windows Millennium network configuration is complete. Continue with SharingYour Files and Printers in the Appendix if you want your PC's data or printer to be available to others on the network.You may stop here, however, if you wish to configure File and Printer Sharing at a later time. Refer to the Troubleshooting section if: • You don't see anything at all in Entire Network and have pressed the F5 key on your keyboard a few times to refresh the screen. • You only see your own computer in Entire Network. •You see all computers on the network except yours and have tried press- ing the F5 key a few times. • You only see computers that are running the same operating system as you and you don't see any others. 33 EtherFast® 10/100 LAN Cards Windows NT 4.0 Installation and Setup Overview The following instructions will set up the EtherFast® Note: If you have 10/100 LAN Card in a computer running NT 4.0 serv- installed any Service Packs, you will need to er/workstation. You should have your original reinstall them after Windows NT CD-ROM available during the installa- installing and setting up tion, as you might be asked to supply it. Always con- the 10/100 LAN Card. sult your NT documentation if you have questions. To install the network driver for an NT 4.0 Server or Workstation 1. Log into Windows NT as an administrator. 2. Click on Start, Settings, Control Panel, and then double-click on the Network icon. 3. If you have not previously installed Windows NT networking on your computer, a message will appear that reads: Windows NT Networking is not installed. Do you want to install it now? • If you see this message, click the Yes button to install NT networking along with the EtherFast Card's network driver, and continue with step 1 on the following page. • If you don't see this message, NT networking is already installed. Skip to the Installing the EtherFast Network Driver if Networking is Already Installed section. 34