Linksys LNE100TX User Guide - Page 25

Linksys Instant EtherFast® Series 5. Highlight the Linksys LNE100TX(v5) Fast Ethernet Adapter entry in the window that appears. Then, click the OK button. EtherFast® 10/100 LAN Cards 10. Remove your Driver Disk and CD-ROM and click the Yes button to restart your PC. 6. When NT asks you for the media type. Choose the AutoSense option. When finished, click the Continue button. Then, click the Close button. 7. If Windows NT asks you to supply your original Windows NT CD-ROM or setup disks, direct Windows NT to the proper location (most likely D:\i386, where D represents the letter of your CD-ROM drive). 11. Once your PC has rebooted, double-click the Network Neighborhood icon on your desktop. Make sure that you have access to the network. If you do, your card has been properly installed. • If you had previously installed any NT service packs, you must re-install them. Otherwise, you may receive Not Enough Service Storage Space errors in the Event Viewer. • If you need to install the TCP/IP protocol, refer to your Windows NT documentation. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol The Windows NT Installation and Setup of the EtherFast® 10/100 LAN Card is complete. Note: If you need to install the TCP/IP Protocol, consult your Windows NT documentation. Linksys does not provide technical support for TCP/IP configuration or troubleshooting. Note: If you had previously installed any NT service packs, you must re-install them. Otherwise, you may receive Not Enough Service Storage Space errors in the Event Viewer. 43 44