Linksys WVC54GCA-RM User Guide - Page 18

Chapter 4 Setup Screen The Setup screen is accessed by clicking the Setup button on the Monitor window of the Camera Utility. There are four tabs along the left side of the Setup screen: Network Camera, Internet Camera, Recording Schedule, and Preferences. By default, the Network Camera tab is selected when the Setup screen is opened. These tabs display screens whose functions are described below. Setup > Network Camera Click the Network Camera tab to set up a network Camera. Installing and Using the Camera Utility Port Number Displays the Camera's port number. User Name and Password Displays the user name. The password is displayed as for security reasons. Enable Motion Detection To enable motion detection recording, check this checkbox. The default is disabled. Click Advanced Configuration to open the Web-based Utility. Click Save to save your changes, or click Exit to exit without saving changes. Click Help to display help information. Setup > Internet Camera To set up a Camera located on the Internet, click the Internet Camera tab, then fill in the fields and click Add. Setup > Network Camera The upper section of the Setup > Network Camera screen contains a list of all Wireless-G Cameras that have been detected (up to 9). The Camera Details section of the screen provides information about the selected Camera. Camera List Enable Check this box to enable the Camera. Uncheck the box to disable the Camera. Camera Name Displays the name of the Camera. IP Address Displays the Camera's IP address. Port Number Displays the Camera's port number. Motion Detection Recording Indicates if motion detection recording is enabled or disabled. Camera Details Camera Name Displays the name of the Camera that you specified while running the Setup Wizard. MAC Address Displays the Camera's MAC address. IP Address Displays the Camera's IP address. Wireless-G Internet Home Monitoring Camera Setup > Internet Camera Camera Name Enter the name assigned to the Camera. MAC Address Enter the Camera's MAC address. IP Address Enter the Camera's IP address. Port Number Enter the Camera's port number. User Name and Password Enter the Camera's user name and password. Stream Type Select either MJPEG or MPEG4 (default). Enable Motion Detection Recording Check the box to enable motion detection recording. The default is disabled. Add After you have entered all of the information for the Camera, click this button to add the Camera to the list. Advanced Configuration Click this button to open the Web-based Utility in your web browser. Click Advanced Configuration to open the Web-based Utility. Click Exit to exit without saving your changes. Click Help to display help information. 17