Lowrance HDS-7 LIVE HDS Live Installation Manual - Page 35

Adjust open array park angle, Tune, Adjust local interference reject, Halo light

Page 35 highlights

Main radar PPI Radar overlay on a chart Adjust open array park angle The park angle is the final resting position of the antenna relative to the heading line of the radar when the radar is set to standby. The antenna will stop rotating at the desired offset. Tune The automatic tuning will work well in most installations. The manual tuning is used if it is required to adjust the result from an automatic tuning. Adjust local interference reject Interference from some onboard sources can interfere with the Broadband radar. One symptom of this could be a large target on the screen that remains in the same relative bearing even if the vessel changes direction. Halo light Controls the levels of the Halo Radar blue accent lighting. The accent lighting can only be adjusted when the radar is in standby mode. Ú Note: The blue accent pedestal lighting might not be approved for use in your boating location. Check your local boating regulations before turning the blue accent lights ON. Reset radar to factory defaults Clears all user and installer settings applied to the selected radar source, and restores factory settings. Software setup | HDS Live Installation Manual 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70

Main radar PPI
Radar overlay on a chart
Adjust open array park angle
The park angle is the final resting position of the antenna relative to
the heading line of the radar when the radar is set to standby. The
antenna will stop rotating at the desired offset.
Tune
The automatic tuning will work well in most installations. The
manual tuning is used if it is required to adjust the result from an
automatic tuning.
Adjust local interference reject
Interference from some onboard sources can interfere with the
Broadband radar. One symptom of this could be a large target on
the screen that remains in the same relative bearing even if the
vessel changes direction.
Halo light
Controls the levels of the Halo Radar blue accent lighting. The
accent lighting can only be adjusted when the radar is in standby
mode.
Ú
Note:
The blue accent pedestal lighting might not be approved
for use in your boating location. Check your local boating
regulations before turning the blue accent lights ON.
Reset radar to factory defaults
Clears all user and installer settings applied to the selected radar
source, and restores factory settings.
Software setup
| HDS Live Installation Manual
35