Magnavox 13MT1532 User manual, English (US) - Page 6

2 Cable Box Connections If you cable signal uses a cable box or decoder, follow the easy steps below to complete the connection. Cable Box (w/RF In/Outputs): This connection will be mono. 1 Connect the Cable Company supplied cable to the signal IN(put) plug on the back of the Cable Box. 2 Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on the back of the Cable Box. 3 Connect the other end of the round coaxial cable to the 75Ω input on the back of the television. Screw it down finger tight. NOTE: If applicable, set the OUTPUT CHANNEL SWITCH on the back of the cable box to CH 3 or 4. Tune the TV to the same channel and change channels at the cable box. In some cases, the cable box will automatically tune to either channel 3 or 4, change channels until the picture appears. Cable Signal IN from the Cable Company 2 TO TV/VCR CABLE IN 1 IR USB VIDEO AUDIO IN SPDIF IN OUT R L DVD-D OUT S-VIDEO AUDIO OUT Y Pb Pr TV PASSCARD OPTICAL SPDIF Jack Panel Back of Cable Box 3 75Ω Round 75Ω Coaxial Cable 75Ω Jack Panel Back of TV Helpful Hints If no Video Signal is present, the TV will display a "BLUE" screen and shut itself off in about 5 minutes. If the TV is tuned to the AV channel and there is no Video Signal present, the screen will remain black and the TV will shut itself off in about 5 minutes.