Makita LS1219L LS1219L Instruction Manual - Page 30
Bevel angle
View all Makita LS1219L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
1 2 3 1 ► 1 . Triangular rule Bevel angle 0° bevel angle Push the carriage toward the guide fence and lock the sliding movement by the stopper pin. Lower the handle fully and lock it in the lowered position by the stopper pin and then loosen the knob. Turn the 0° adjusting bolt two or three revolutions counterclockwise to tilt the blade to the right. 1 2 ► 1 . Triangular rule 2. Saw blade 3. Top surface of turn base Check if the side of the blade squares with the turn base surface once again. Loosen the screw on the pointer. Align the pointer with 0° position in the bevel angle scale and then tighten the screw. 45° bevel angle NOTICE: Before adjusting the 45° bevel angle, finish 0° bevel angle adjustment. Loosen the knob and fully tilt the carriage to the side that you want to check. Check if the pointer indicates the 45° position in the bevel angle scale. ► 1 . 0° Adjusting bolt 2. Screw Carefully square the side of the blade with the top surface of the turn base using the triangular rule, trysquare, etc. by turning the 0° adjusting bolt clockwise. Then tighten the knob firmly to secure the 0° angle you have set. If the pointer does not indicate the 45° position, align it with 45° position by turning the adjusting bolt on the opposite side of the bevel angle scale. 30 ENGLISH