Makita LS1219L LS1219L Instruction Manual - Page 32
Optional, Accessories
View all Makita LS1219L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
7. Slide the adjusting screw to the position that the laser line comes onto the cutting line and then tighten. NOTE: The movable range of laser line is factory 1 adjusted within 1 mm (0.04") from the side surface of blade. Cleaning the laser light lens For model LS1219L only The laser light becomes hard to see as the lens for the laser light gets dirty. Clean the lens for laser light periodically. 1 2 ► 1 . Brush holder cap After replacing brushes, plug in the tool and break in brushes by running tool with no load for about 10 minutes. Then check the tool while running and electric brake operation when releasing the switch trigger. If the electric brake is not working correctly, have the tool repaired by a Makita service center. After use ► 1 . Screw 2. Lens Unplug the tool. Loosen the screw and pull out the lens. Clean the lens gently with a damp soft cloth. NOTICE: Do not remove the screw which secures the lens. If the lens does not come out, loosen the screw further. NOTICE: Do not use solvents or any petroleum-based cleaners on the lens. Replacing carbon brushes After use, wipe off chips and dust adhering to the tool with a cloth or the like. Keep the blade guard clean according to the directions in the previously covered section titled "Blade guard". Lubricate the sliding portions with machine oil to prevent rust. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES WARNING: These Makita accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments may result in serious personal injury. WARNING: Only use the Makita accessory or attachment for its stated purpose. Misuse of an accessory or attachment may result in serious personal injury. 1 ► 1 . Limit mark Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. • Steel & Carbide-tipped saw blades • Vertical vise • Horizontal vise • Crown molding stopper set • Dust bag • Triangular rule • Hex wrench • Hex wrench (for LS1219L) NOTE: Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. 32 ENGLISH