Makita LS1219L LS1219L Instruction Manual - Page 6

7. Always secure all moving portions before carrying the tool. 8. Stopper pin which locks the cutter head down is for carrying and storage purposes only and not for any cutting operations. 9. Check the blade carefully for cracks or damage before operation. Replace cracked or damaged blade immediately. Gum and wood pitch hardened on blades slows saw and increases potential for kickback. Keep blade clean by first removing it from tool, then cleaning it with gum and pitch remover, hot water or kerosene. Never use gasoline to clean blade. 10. While making a slide cut, KICKBACK can occur. KICKBACK occurs when the blade binds in the workpiece during a cutting operation and the saw blade is driven rapidly towards the operator. Loss of control and serious personal injury can result. If blade begins to bind during a cutting operation, do not continue to cut and release switch immediately. 11. Use only flanges specified for this tool. 12. Be careful not to damage the arbor, flanges (especially the installing surface) or bolt. Damage to these parts could result in blade breakage. 13. Make sure that the turn base is properly secured so it will not move during operation. Use the holes in the base to fasten the saw to a stable work platform or bench. NEVER use tool where operator positioning would be awkward. 14. Make sure the shaft lock is released before the switch is turned on. 15. Be sure that the blade does not contact the turn base in the lowest position. 16. Hold the handle firmly. Be aware that the saw moves up or down slightly during start-up and stopping. 17. Make sure the blade is not contacting the workpiece before the switch is turned on. 18. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced blade. 19. Stop operation immediately if you notice anything abnormal. 20. Do not attempt to lock the trigger in the "ON" position. 21. Always use accessories recommended in this manual. Use of improper accessories such as abrasive wheels may cause an injury. 22. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. Additional safety rules for the laser 1. LASER RADIATION DO NOT STARE INTO BEAM. 2. AVOID EXPOSURE - LASER RADIATION IS EMITTED FROM APERTURE. 3. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. Complies with 21CFR 1040.10 and 1040.11 AVOID EXPOSURE-Laser radiation is emitted from this aperture CAUTION LASER RADIATION DO NOT STARE INTO BEAM Maximum Output