Makita XAG21ZU XAG20/XAG21 Instruction Manual - Page 16
Tool registration for the vacuum, cleaner
View all Makita XAG21ZU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
3 1 1 2 ► 1 . Wireless unit 2. Hook 3. Lid After removing the wireless unit, keep it in the supplied case or a static-free container. NOTICE: Always use the hooks on the back of the lid when removing the wireless unit. If the hooks do not catch the wireless unit, close the lid completely and open it slowly again. Tool registration for the vacuum cleaner NOTE: A Makita vacuum cleaner supporting the wireless activation function is required for the tool registration. NOTE: Finish installing the wireless unit to the tool before starting the tool registration. NOTE: During the tool registration, do not pull the switch trigger or turn on the power switch on the vacuum cleaner. NOTE: Refer to the instruction manual of the vacuum cleaner, too. If you wish to activate the vacuum cleaner along with the switch operation of the tool, finish the tool registration beforehand. 1. Install the batteries to the vacuum cleaner and the tool. 2. Set the stand-by switch on the vacuum cleaner to "AUTO". ► 1 . Stand-by switch 3. Press the wireless activation button on the vacuum cleaner for 3 seconds until the wireless activation lamp blinks in green. And then press the wireless activation button on the tool in the same way. 1 2 1 2 ► 1 . Wireless activation button 2. Wireless activation lamp If the vacuum cleaner and the tool are linked successfully, the wireless activation lamps will light up in green for 2 seconds and start blinking in blue. 16 ENGLISH