Makita XAG21ZU XAG20/XAG21 Instruction Manual - Page 21

State of abnormality The vacuum cleaner does not run along with the switch operation of the tool. The vacuum cleaner runs while the tool's switch trigger is not pulled. Probable cause (malfunction) Remedy The wireless unit is not installed into the tool. The wireless unit is improperly installed into the tool. Install the wireless unit correctly. The terminal of the wireless unit and/or Gently wipe off dust and dirt on the terminal of the the slot is dirty. wireless unit and clean the slot. The wireless activation button on the tool has not been pushed. Push the wireless activation button briefly and make sure that the wireless activation lamp is blinking in blue. The stand-by switch on the vacuum cleaner is not set to "AUTO". Set the stand-by switch on the vacuum cleaner to "AUTO". More than 10 tools are registered to the vacuum cleaner. Perform the tool registration again. If more than 10 tools are registered to the vacuum cleaner, the tool registered earliest will be cancelled automatically. The vacuum cleaner erased all tool registrations. Perform the tool registration again. No power supply Supply the power to the tool and the vacuum cleaner. The tool and vacuum cleaner is away from each other (out of the transmission range). Get the tool and vacuum cleaner closer each other. The maximum transmission distance is approximately 10 m however it may vary according to the circumstances. Radio disturbance by other appliances which generate high-intensity radio waves. Keep the tool and vacuum cleaner away from the appliances such as Wi-Fi devices and microwave ovens. Other users are using the wireless activation of the vacuum cleaner with their tools. Turn off the wireless activation button of the other tools or cancel the tool registration of the other tools. MAINTENANCE CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Air vent cleaning The tool and its air vents have to be kept clean. Regularly clean the tool's air vents or whenever the vents start to become obstructed. 1 Remove the dust cover from inhalation vent and clean it for smooth air circulation. 1 ► 1 . Dust cover NOTICE: Clean out the dust cover when it is clogged with dust or foreign matters. Continuing operation with a clogged dust cover may damage the tool. 2 ► 1 . Exhaust vent 2. Inhalation vent 21 ENGLISH