Makita XAG21ZU XAG20/XAG21 Instruction Manual - Page 9

Overheat protection When the tool is overheated, the tool stops automatically and the battery indicator shows following state. In this situation, let the tool cool before turning the tool on again. On Blinking If the tool does not start, the battery may be overheated. In this situation, let the battery cool before starting the tool again. Overdischarge protection When the battery capacity is not enough, the tool stops automatically. In this case, remove the battery from the tool and charge the battery. Releasing protection lock When the protection system works repeatedly, the tool is locked and the battery indicator shows the following state. In this situation, the tool does not start even if turning the tool off and on. To release the protection lock, remove the battery, set it to the battery charger and wait until the charging finishes. Switch action CAUTION: Before installing the battery cartridge into the tool, always check to see that the switch lever actuates properly and returns to the "OFF" position when released. CAUTION: Do not pull the switch lever hard without pulling the lock-off lever. This can cause switch breakage. CAUTION: For your safety, this tool is equipped with lock-off lever which prevents the tool from unintended starting. NEVER use the tool if it runs when you simply pull the switch trigger without pulling the lock-off lever. Return the tool to our authorized service center for proper repairs BEFORE further usage. CAUTION: NEVER tape down or defeat purpose and function of lock-off lever. To prevent the switch lever from being accidentally pulled, a lock-off lever is provided. To start the tool, pull the lock-off lever toward the operator and then pull the switch lever. To stop the tool, release the switch lever. On Off Blinking Shaft lock Press the shaft lock to prevent spindle rotation when installing or removing accessories. 1 1 2 ► 1 . Lock-off lever 2. Switch lever Speed adjusting dial The rotation speed of the tool can be changed by turning the speed adjusting dial. The table below shows the number on the dial and the corresponding rotation speed. 1 ► 1 . Shaft lock NOTICE: Never actuate the shaft lock when the spindle is moving. The tool may be damaged. ► 1 . Speed adjusting dial 9 ENGLISH