Makita XAG21ZU XAG20/XAG21 Instruction Manual - Page 20

Troubleshooting for wireless activation function Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replacement parts for repairs. State of abnormality The wireless activation lamp does not light/blink. Cannot finish tool registration / cancelling tool registration successfully. Probable cause (malfunction) Remedy The wireless unit is not installed into the tool. The wireless unit is improperly installed into the tool. Install the wireless unit correctly. The terminal of the wireless unit and/or Gently wipe off dust and dirt on the terminal of the the slot is dirty. wireless unit and clean the slot. The wireless activation button on the tool has not been pushed. Push the wireless activation button on the tool briefly. The stand-by switch on the vacuum cleaner is not set to "AUTO". Set the stand-by switch on the vacuum cleaner to "AUTO". No power supply Supply the power to the tool and the vacuum cleaner. The wireless unit is not installed into the tool. The wireless unit is improperly installed into the tool. Install the wireless unit correctly. The terminal of the wireless unit and/or Gently wipe off dust and dirt on the terminal of the the slot is dirty. wireless unit and clean the slot. The stand-by switch on the vacuum cleaner is not set to "AUTO". Set the stand-by switch on the vacuum cleaner to "AUTO". No power supply Supply the power to the tool and the vacuum cleaner. Incorrect operation Push the wireless activation button briefly and perform the tool registration/cancellation procedures again. The tool and vacuum cleaner is away from each other (out of the transmission range). Get the tool and vacuum cleaner closer to each other. The maximum transmission distance is approximately 10 m however it may vary according to the circumstances. Before finishing the tool registration/ cancellation; - the switch trigger on the tool is pulled or; - the power button on the vacuum cleaner is turned on. Push the wireless activation button briefly and perform the tool registration/cancellation procedures again. The tool registration procedures for the Perform the tool registration procedures for both the tool or vacuum cleaner has not finished. tool and the vacuum cleaner at the same timing. Radio disturbance by other appliances which generate high-intensity radio waves. Keep the tool and vacuum cleaner away from the appliances such as Wi-Fi devices and microwave ovens. 20 ENGLISH