Makita XAG21ZU XAG20/XAG21 Instruction Manual - Page 19

Cancelling tool registration for the vacuum cleaner Perform the following procedure when cancelling the tool registration for the vacuum cleaner. 1. Install the batteries to the vacuum cleaner and the tool. 2. Set the stand-by switch on the vacuum cleaner to "AUTO". If the cancellation is performed successfully, the wireless activation lamps will light up in red for 2 seconds and start blinking in blue. NOTE: The wireless activation lamps finish blinking in red after 20 seconds elapsed. Press the wireless activation button on the tool while the wireless activation lamp on the cleaner is blinking. If the wireless activation lamp does not blink in red, push the wireless activation button briefly and hold it down again. 1 ► 1 . Stand-by switch 3. Press the wireless activation button on the vacuum cleaner for 6 seconds. The wireless activation lamp blinks in green and then become red. After that, press the wireless activation button on the tool in the same way. 1 2 1 2 ► 1 . Wireless activation button 2. Wireless activation lamp 19 ENGLISH