Maytag MDB4651AWS Installation Instructions - Page 13

7, Reinstall the top sound barrier strip by sliding the strip onto the top of the dishwasher door. 1, Check that the utilities are installed correctly and in the correct location. 5, For power supply cord installations--route the power supply cord through the cutout in the cabinet. 6. Move the dishwasher completely into the cabinet opening. NOTE: Do not kink or pinch the water line, drain hose, power supply cord or direct wire between the dishwasher and the cabinet. 7. Remove the cardboard from underneath the dishwasher. NOTES: • If the dishwasher fits tightly into the cabinet opening, do not remove the insulation blanket. The blanket reduces the sound level. • If using the power supply cord, check that the cord is routed through the hole in the cutout before sliding the dishwasher into the cabinet opening. 8. Align the front of the dishwasher with the front of the cabinet doors. You may need to adjust the alignment to be even with the cabinets. 9. Check that the leveling legs are firmly against the floor. B 10. Close and latch the door, and place the level against the front panel. 11. Check that the dishwasher is centered from front to back in the opening. If needed, adjust the leveling leg until the dishwasher is plumb. A. Water line B. Direct wire connection only 2, Grasp the sides of the dishwasher door panel and move the dishwasher close to the cabinet opening. NOTE: Do not push on the front of the door panel or on the console to avoid damage to the dishwasher. 3, Check that utilities are taped to the floor in the correct locations. 4. Check that the water line is on the left-hand side of the cabinet opening. 13