Maytag MED7500YW Use & Care Guide - Page 14

Power Supply Cord Connection Power supply cord strain relief: 1. Attach power supply cord to strain relief 4-Wire Power Supply Cord Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. A B C Unscrew the strain relief (A) from the terminal block cover. Unscrew the strain relief nut (B) from the strain relief (A). Put the power supply cord (C) through the strain relief nut (B), then the strain relief (A). Be sure that the wire insulation on the power supply cord is inside the strain relief. 2. Replace strain relief 4-wire receptacle (NEMA type 14-30R) 4-prong plug Spade terminals with upturned ends Ring terminals 1. Remove neutral ground wire A B C D Replace strain relief (B) (with power cord [D] inserted) back into the terminal block cover (A). Do not tighten strain relief nut (C). If your outlet looks like this: Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to "4-Wire Power Supply Cord Connection" on this page. If your outlet looks like this: Power supply cord 3-wire receptacle (NEMA Type 10-30R): Go to "3-Wire Power Supply Cord Connection" on page 15. 14 F A B Remove the neutral ground wire (F) located inside the dryer cabinet, behind the external ground conductor screw (A). 2. Connect ground wire and neutral wire B D A E Connect ground wire (E) (green or bare) of power supply cord to external ground conductor screw (A). Tighten screw. Connect neutral wire (D) (white or center wire) of power supply cord under center screw (B) of the terminal block.