Maytag MED7500YW Use & Care Guide - Page 21

LEVEL DRYER 1. Level dryer Place level here Check levelness of dryer from side to side. Repeat from front to back. NOTE: The dryer must be level for the moisture sensing system to operate correctly. Not Level LEVEL 2. Adjust leveling legs Not Level COMPLETE INSTALLATION CHECKLIST q Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. q Check that you have all of your tools. q Dispose of/recycle all packaging materials. q Check dryer's final location. Be sure vent is not crushed or kinked. q Check that dryer is level. See "Level Dryer". q Remove film on console and any tape remaining on dryer. q Wipe dryer drum interior thoroughly with a damp cloth to remove any dust. q Read "Using Your Dryer." q For power supply cord installation, plug into a grounded outlet. For direct wire installation, turn on power. q Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer. If dryer will not start, check the following: • Controls are set in a running or "On" position. • Start button has been pushed firmly. • Dryer is plugged into an outlet and/or electrical supply. • Household fuse is intact and tight, or circuit breaker has not tripped. • Dryer door is closed. NOTE: You may notice an odor when dryer is first heated. This odor is common when heating element is first used. The odor will go away. If dryer is not level, prop up using a wood block, use wrench to adjust legs up or down, and check again for levelness. Once dryer is level, make sure all four legs are snug against the floor and dryer does not rock. 21