Maytag MED7500YW Use & Care Guide - Page 9
Installation Instructions - model
View all Maytag MED7500YW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
INSTALLATION INSTRUCTIONS INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather the required tools and parts before starting installation. Tools needed: Flat-blade screwdriver Wood block Wire stripper (direct wire installations) Tin snips (new vent installations) Parts needed: (Not supplied with dryer) Vent clamps Vent elbows and ductwork Additional parts may be required, depending on your installation. Check local codes. Check existing electrical supply and venting. Read "Electrical Requirements" and "Venting Requirements" before purchasing parts. If using a power supply cord: Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should contain: n A UL listed 30-amp power supply cord, rated 120/240 volt minimum. The cord should be type SRD or SRDT and be at least 4 ft. (1.22 m) long. The wires that connect to the dryer must end in ring terminals or spade terminals with upturned ends. n A UL listed strain relief. Parts supplied: Parts package is located in dryer drum. Check that all parts are included. NOTE: Do not use leveling legs supplied if installing with a pedestal or a stack kit. 1/4" (7 mm) nut driver (recommended) Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench Level Caulking gun and compound (for installing new exhaust vent) Torx® T20 screwdriver Coupling Options: (Not supplied with dryer) Pedestal You may order a pedestal separately for this dryer. This pedestal will add about 12" (305 mm) to the height of your unit for a total height of approximately 45" (1.14 m). To order, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section of this manual. Ask for Model Number LAB0050PQ. Stack kit Are you planning to stack your washer and dryer? Your dryer is shipped with Stack Kit W10178021, which fits Maytag washer models starting with MHWC. If you have any other washer model, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section of this manual. ® TORX is a registered trademark of Saturn Fasteners, Inc. 9